1. Cut the lamp band

The cutting method of the light strip is that in fact, every meter of the blank space of the light strip is a cutting point. If you cut it in other places, the line of this light strip will be damaged, causing damage to the light strip.

2. Connector socket

Insert one end of the tip of the connector needle into the light strip wire, ensure that the needle is in contact with the wire, and insert it to the low end to ensure full conductivity.

3. Connect the power cord

Align the other end of the connector connected to the light strip with the pin port of the power cord and insert it. The power cord plug will light up when it is powered on. If the light strip does not light up, you can insert the other end of the light strip from the second step.

4. Tail plug closed

Plug the tail plug of the power cord to ensure the safe use of the circuit.